How to determine the position of the outlet pipe of the stainless steel water tank?

In different workplaces, we need to adopt different installation methods to install stainless steel water tanks, and the selected location also varies. In this way, there will also be some changes in the location selection when designing its outlet pipe. Normally, the diameter of the outlet pipe used is 15mm. We can connect the water outlet pipe to the water room and other places.
However, if it is necessary to link the liquid level of the stainless steel water tank with the water pump, a liquid level relay or signal device needs to be installed on the side wall or top cover of the water tank. The commonly used liquid level relays and signals mainly include rod type, float type, capacitor type, and float type. It should be noted that the pressure of the water pump entering the water tank and the electric control water level need to maintain an appropriate safe volume.
For example, when stopping the pump, it should be ensured that the high electric control water level of the stainless steel water tank is at least 100MM lower than its overflow water level, and when starting the pump, the low electric control water level generated should be at least 200MM higher than the design low water level. This is mainly to prevent errors from causing adverse consequences such as water overflow or water storage emptying.
Of course, if necessary, we can set the stainless steel water tank outlet pipe on its side wall or connect it from the bottom. It should be noted that as the amount of ferrite increases, its toughness value will gradually decrease, mainly due to the incorporation of carbon, nitrogen, and oxygen elements.
The above is mainly a brief analysis of some issues that we need to consider when designing the position of the stainless steel water tank outlet pipe. I hope these contents can provide some reference for everyone